Thingiverse
Smartphone Table Stand, Holder
von joaopauloooo
6
Downloads
1
Likes
1
Makes
Designed up this phone stand to hold your phone on a table.
It has 2 angles that you can use by turning it upside down.
Printing:
No support required
Minimum infill: 20%
Minimum quality: 0.28
If you have a good base then there is no need to add adhesion.
It has 2 angles that you can use by turning it upside down.
Printing:
No support required
Minimum infill: 20%
Minimum quality: 0.28
If you have a good base then there is no need to add adhesion.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!