SmartRain Sensor Holder (Rain Sensor)

This is my little smart rain sensor! I've seen a few of these knocking around on other sites, but thought I'd have a stab at one myself, that looks a little prettier :-) The idea is that the device can either stay outside permanently, or act as an aid when clothes washing is on the line. I've made it so it can be easily taken in and out as necessary. Things you need to make it3D Printer (obviously)2 screws to fit it to a postA rain sensor board such as this.A water sensor such as this. I have based it on the Aqara water sensor, so not sure if others will fit.InstructionsWire the sensor to the rain drops board as the photoSlide the rain drop board into the casing, drop the water sensor into the large part, then the two sit ontop of eachother. Note, they should balance using the small square to help locate them.Take the top piece (with the writing on it) and it should nicely clip over the top of the two pieces which hold it all securely in place.Slide the back triangles into