Thingiverse
Smoke Helmet
door Snorri
176
Downloads
162
Likes
0
Makes
Smoke helmet reproduction.
You may need to size the mask down, the current size makes it a little bit too big, reducing 25% should be better (but check it first).
Epoxy the parts together 1 2 3 4 together
parts 5 and 7 are to be glued back to back (it's easier to glue the part number 7 to the helmet (flat face up) and then glue part 5 to it to get a good alignement.
You may need to size the mask down, the current size makes it a little bit too big, reducing 25% should be better (but check it first).
Epoxy the parts together 1 2 3 4 together
parts 5 and 7 are to be glued back to back (it's easier to glue the part number 7 to the helmet (flat face up) and then glue part 5 to it to get a good alignement.
Snorri publiceert ook op
63 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
