Smooth Q Counter Weight

Clamp-on counterweight to balance the Smooth Q Gimbal. I built this out of necessity after printing the Smooth Q Gopro Hero 5 adapter located here [https://www.thingiverse.com/thing:2740361](https://www.thingiverse.com/thing:2740361) I searched for a while on this site for a suitable build and then checked out some commercially available options. I decided that I wanted something clean, simple and able to use the 3/8" nuts that I had on-hand for weight.

The threads match up very well as printed on my Ender 3, your results may vary.

This design requires at least 2 3/8x16 nuts to provide the clamping power but can accept up to 8. Each nut weighs about 10.5g so that gives you a range of 21-84g in 10.5g increments.

I've only tested it on the Smooth Q Gimbal but I suppose due to it's simple nature that it could be used on others