Snake skin bookmark 03

In the print project, the negative part is inserted. If you dont want a hole in the bookmark, remove it before the print. Model size is 50x150mm, you can scale the size, but when changing dimensions, you must not change the height (Z). Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.  You may print at higher layer heights below the Min Depth of 0.48mm  The Max Depth is 2mm and the Actual Depth is 2mm Filaments Used: PLA Elegoo + Black Transmission Distance: 0.3 PLA Sunlu META Grey Transmission Distance: 8.1 PLA Elegoo + White Transmission Distance: 8.9 This print uses 3 unique filaments Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Grey At layer #15 (1.28mm) swap to White for the rest.