Snakebite Caliburn Mod Set REAR HALF

Snakebite is a "minimum draw" Caliburn project with "AR" inspired looks. Based on pre-takedown Caliburns, I have shortened this project down to a 4.6" draw, which I consider the minimum to retain full length dart compatibility. Top rails have also been raised over stock, no angle applied.

This is the pieces for the rear half of the blaster. Trigger and mag release lever are the exact same as the original. You will need to print the new sear and plunger included and all pieces will need to be printed, this is not compatible with existing parts *visually*. Threaded rod locations have not changed, blaster will still assemble per stock. I have successfully adapted the Worker Metal kit for use in this project, though modification of the kit is necessary.

Modifications required will be cutting of threaded rods, plunger tube, stock springs.

***NOTE: There are no modification instructions included at this time, basic instructions to follow.