Thingiverse
SNAP-COIN
door vikingfabian
36
Downloads
21
Likes
1
Makes
Coin tokens that you print in different colors and then snap together.
Each coins consists of 1 mid piece and 2 faces.
--Printer
0.2mm layer height
Use support on the mid sections
The faces require a good bed level. Using a skirt also helps.
--Content
Mid section, 25mm/1inch wide.
-4mm height: for most uses
-7mm height: designed for miniature replacements (like dnd figures)
Wider mid sections, 27mm, 30mm and 32mm. 4mm height. Designed to make larger values represented by size.
Faces 1 to 12, 20, 25, 50 & 100.
Roman faces I, V & X.
Decorated faces 1 to 12.
-UPDATE1
Added higher number faces and roman numbers
Each coins consists of 1 mid piece and 2 faces.
--Printer
0.2mm layer height
Use support on the mid sections
The faces require a good bed level. Using a skirt also helps.
--Content
Mid section, 25mm/1inch wide.
-4mm height: for most uses
-7mm height: designed for miniature replacements (like dnd figures)
Wider mid sections, 27mm, 30mm and 32mm. 4mm height. Designed to make larger values represented by size.
Faces 1 to 12, 20, 25, 50 & 100.
Roman faces I, V & X.
Decorated faces 1 to 12.
-UPDATE1
Added higher number faces and roman numbers
vikingfabian publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!