Thingiverse
Snap-In Printer Feet
von TheSylencer
5
Downloads
10
Likes
0
Makes
After being tired of printer feet that require you to take half the machine apart to install, (at least that's what it felt like) I decided to design a snap-in version.
This was designed for my Voxelab aquila x2, but I have no doubt it will fit MOST other machines. This design does fit a little bit loose to avoid problems with it fitting.
It's also worth noting this requires you to push on the machine a little harder than most people would prefer. if you have problems with this, I will try to help.
This was designed for my Voxelab aquila x2, but I have no doubt it will fit MOST other machines. This design does fit a little bit loose to avoid problems with it fitting.
It's also worth noting this requires you to push on the machine a little harder than most people would prefer. if you have problems with this, I will try to help.
TheSylencer veröffentlicht auch auf
20 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
