Snap-On 2.5" HDD/SSD Case

I couldn't find any 2.5" HDD/SSD cases that didn't require any extra hardware, so I made this.

There are two sizes. If your drive is 6.5mm thick, print two of the shorter halves. If your drive is 9.3mm thick, print one short half and one long half.

To assemble, angle the drive to easily insert one side of the placement pins, then lay the drive down and snap in the other side. When you go to slot in the other half, you may need to spin it around 180 degrees to make the pins align.

Print flat-side down. My printer (Snapmaker U1) didn't need supports to make the placement pins, but yours might.