Snap-on LED sign

Snap-on LED signPerfect for garage or workshop Assembled Dimensions:Width: 26.75 inchesHeight: 8.25 inchesDepth: 1.25 inches Requirements:-4m white LED strip (Aliexpress)-12v 2a power supply (Aliexpress)-5.5*2.1mm DC Male Cable Connector 2pin (AliExpress)-3 M3x16 screw (Optional, each letter could be glued with CA glue)-8 M3 Bolt (Optional, each letter could be glued with CA glue) Instructions:1- Print all body STLs. For better result use ironing or set the top surface pattern to Hilbert Curve (add Height range modifier to the last layer only to save on print time)2- Join all 3 body parts with screws3- Install the DC Male cable connector4- Solder the positive and negative wired to the LED strip terminal5- Stick the led strip around each letter below the letter insert line6- Print the letter insert STLYou have 2 differents options here: 1.2mm or 0.8mm wall. Depending on your filament you might need ticker wall to get better result when the LED are on. A good test would be to print the “