Slicer Discord
Snap-on Soup Can Lid – 3D-Druckmodell von Thingiverse Thingiverse

Snap-on Soup Can Lid

47 Downloads
22 Likes
0 Makes
Zum Modell
My wife requested a cap that could snap on to the top of a can to help keep the contents fresh while in the refrigerator. She had been using plastic wrap, but we both felt that that was wasteful, since you can only get a few uses out of it. A reusable lid would be less wasteful over time.

I did a search here on Thingiverse and found a few designs that would sit on the top of the can, but I felt like one that could snap on and hold would be better. So, here is what I came up with. It has a good, positive snap when putting on the lid, and it stays in place if accidentally tipped over.

Notes:
1. This is designed to fit a 3 inch (75mm) steel can. Can sizes vary by manufacturer, so you may need to scale up or down a percent or two for a perfect fit.
2. I used PETG. Whichever filament you use, it should be one that has some flexibility to it. PLA is likely too brittle and would likely crack easily.
3. The version 2 (V2) file includes more slots in the rim of the lid. Th
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, PETG
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen