Thingiverse
Snap-on Spool Holder
von ItsNeptun
1
Downloads
3
Likes
0
Makes
Snap on spool holder for Spools used by DasFilament.de.
Spools are produced by Häfner, so it should work with spools from other filament suppliers that use these spools.
The diameter of the snap-on circle is 52.5 mm.
The diameter of the center is 10.5 mm to work with 10 mm rods
Spools are produced by Häfner, so it should work with spools from other filament suppliers that use these spools.
The diameter of the snap-on circle is 52.5 mm.
The diameter of the center is 10.5 mm to work with 10 mm rods
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
