Snap-On Tool Holder

I like to keep my snap on tools and batteries separated when not in use, however I could not find a model that kept my tools upright without paying for it. If that was the case, I decided to design my own and share it with you guys. I hope you can find these useful. I recommend PETG for these as its pretty chemical resistant, but they can be printed if PLA just fine as well. There are 2 models I've uploaded as well:Tight Fit andReduced Tolerance Fit The Tight fit model is almost a press fit for the tools and holds them very securely. Id recommend bolting these down to a heavy backer and if your filament is not perfectly dry or calibrated they may fit too tightly. The reduced Tolerance fit is just as it sounds, they are designed with a little more tolerance and and do not normally grab the inside of the tool like the tight fit model does. These do not need to be attached to a backer since they are loose and usually don't grab.