Snap Together Case for xEM Access Controller v2

This case is designed to hold the PCB from an xEM access controller. The two parts snap together after printing, a bit of force is needed, but I think I've got a working design (at least with my tolerances). I would love some feedback on this design from anyone who has printed and used this so I can continue to change tolerances as needed.



One side acts as a hinge whereas the other side snaps together with the case. It is a bit of a loose fit and may rattle a little bit if it were to be mounted in a car, so I would likely chuck a bit of electrical tape around it to hold it securely.

The hole spacing is the same as the coil cover plate which can be found [here](https://www.thingiverse.com/thing:4589008)