Slicer Discord
snap together glider v2 – 3D-Druckmodell von MakerWorld MakerWorld
Outdoor Toys

snap together glider v2

29 Downloads
3 Likes
13 Makes
Zum Modell
this glueless design offers similar performance without the mess....ideal for young makers to build, without worrying about stuck fingers! Instructions Description: An efficient conventional glider with glueless assembly, ideal for looping flights and long glides.Plastic: ABS, PLA, PETG, NYLONLayers: .20mmFill: 25%Perimeters: 2Solid Layers: 2filament use / weight (3mm) : Approx 1350mmOrientation:first layer lentghwise (0 degrees to fuselage), altrenate by 90 degrees. A 45 degree (or non right angle) axis will cause asymetrical wing warping under load (bad).Build Notes:Allow to cool before carefully removing from build platform. The wings are easily deformed during removal, and must be absoultely symmetrical for proper flight. Removal with a very thin plastic spatula (print one!) is preferred. Test fit all parts and trim if necesary prior to final assembly.The dihedral joint is assembled by clamping along the top of the fuselage between the wings with the dihederal clip to establish dih
Kategorie
Outdoor Toys
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ABS, PETG
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen