Slicer Discord
SnapCap Canister – 3D-printbaar model van MakerWorld MakerWorld
Organizers

SnapCap Canister

door AuxArc · Organizers
362 Downloads
305 Likes
184 Makes
Model downloaden
This small canister would be perfect for storing a mozzarella stick on your backpack or climbing harness for an easily accessible mid-send snack, if storing mozzarella sticks outside for long periods of time was a recommended activity. Sadly, it's not. Alternatively, I recommend keeping tool bits (Perfect for impact drills when routesetting in a climbing gym, for example, or working from a harness in the industrial world), chapsticks, batteries, dog treats, hydration packs, etc in these. Will work with pretty much any carabiner. I have a 4" and 2.5" version attached. You'll need two small M3 x 6mm Socket head screws. Slide the lid on top and screw the M3s directly into the body through the slots. The top quarter of the slot will latch the M3 head to keep it in place once they're install. To open, pop the cap upwards and pivot it over to the side. Can be printed with no supports as long as the cap is oriented upside down, sitting on the loop. I print with 4 walls, gy
Categorie
Organizers
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Waarom?
geen supports
Zonder supports Eendelig Hardware nodig
Supports 0/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, Polycarbonate
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

AuxArc publiceert ook op

6 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie