SnapLock Storage Boxes (parametric)

Patreon : If you would like to support my work I now have a patreon hereUPDATE : I redesigned the sketch for the gasket as it didn't follow the goemetry properlyF3d files can fe found here : I revamped the SnapLock storage boxes, transforming them into parametric Fusion 360 files. Additionally, I integrated a gasket for improved alignment between the two sides, and implemented a poka yoke mechanism to prevent incorrect mounting of the latches.With the original model, I was surprised to notice that many people tend to assemble the latch backward, resulting in difficulty when opening it. In this new model, I've incorporated a small bump to prevent backward mounting entirely.Disclaimer :This is my first model using Fusion 360, I usually use Solidworks. Please be understanding if there are any mistakes in the model. Additionally, I have not set specific limits on the parameters but have provided minimum values in the comments. Should you attempt to go below these minimum values, th