Snapmaker 2.0 Power Supply Bracket Front

This is my version of the Snapmaker 2.0 power supply bracket. I saw that there are many on here and other sites that try to hide this power supply (and its Turbine sounding fan). I didn't have the enclosure so and I didn't want to poke holes in my drawer unit or wall so I made this bracket to be mounted, using double-sided tape, to the side of my drawer unit. This way I don't have to poke any holes in anything and the double-sided tape I used was quite thick and acted as a buffer so the vibrations don't transfer to the drawer and make it even louder!

This is the front of the power supply. I also have the rear part as well here https://www.thingiverse.com/thing:4803259. I separated them because if you want the same look for the front and back, you can just mirror it and keep the look you want.

I printed this one in a glow-in-the-dark filament so when the light from the power supply turns on it will charge it up and glow after I turn it off. Silly I know but I wanted to try out my GID