Thingiverse
Snapmaker 2 Encloser Controller Bumper Case
por frog_dude
1
Descargas
2
Likes
0
Makes
It blocks the opening in the encloser in the front to help block drafts, laser light, etc.
I knocked the controller off a few times so I added a some hooks to wrap a rubber band around the back to hold the controller on.
The only downside is a I see it adds a little gap on the door opening.
The base was taken from: sdj544 - https://www.thingiverse.com/thing:4572483.
I knocked the controller off a few times so I added a some hooks to wrap a rubber band around the back to hold the controller on.
The only downside is a I see it adds a little gap on the door opening.
The base was taken from: sdj544 - https://www.thingiverse.com/thing:4572483.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
