Snapmaker 2 enclosure GoPro mount

This lets you attach the GoPro to the Snapmaker 2 enclosure, either above or below the door sensor, on the same aluminum extrusion that holds it using holes and screws that come with the enclosure.

To mount, one end goes into the corner extrusion's gap, and another gets screwed into the extrusion using existing holes and screws that come with the printer. If mounting at the top position, be careful to first pull the wire out of the extrusion gap, install this part, and then there'll be enough room left to tuck the wire back in without crushing it.

The photos show actual images taken with a GoPro Hero 8 Black with different lens angles and at both positions. Also tested with the Media Mod (still fits just fine). Minor caveat is that you'll likely want a right-angle USB-C adapter if you want to keep the camera charging while it's mounted.

Fusion 360 file is included so others can remix if they want to (there's a user parameter for the angle that the camera faces relative to the