Thingiverse
Snapmaker A350 Filament guide
von sdj544
82
Downloads
38
Likes
2
Makes
Filament guides for Snapmaker A350
UPDATE: After using for a while I now prefer the B version with the circular guide. The long skinny one was just too easy to bump into and snap off while doing other stuff.
I was able to keep my filament roll inside the the enclosure by just lowering it a few screw holes.
The only problem I've found with this is that the filament will sometimes wrap around the z-tower (especially after going to home position) This keeps it from doing that.
I printed this in PETG but PLA should work just fine.
Not sure if it would work on an A250. Let me know if it does.
UPDATE: After using for a while I now prefer the B version with the circular guide. The long skinny one was just too easy to bump into and snap off while doing other stuff.
I was able to keep my filament roll inside the the enclosure by just lowering it a few screw holes.
The only problem I've found with this is that the filament will sometimes wrap around the z-tower (especially after going to home position) This keeps it from doing that.
I printed this in PETG but PLA should work just fine.
Not sure if it would work on an A250. Let me know if it does.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
