Snapmaker BoogerHooks

That little piece of filament the printer extrudes before printing, then dangling off the front corner of the build plate has always irritated me a bit. Since there is nothing to grab hold of it or bump into it to knock it loose, I made these hooks to clip in between the display and the y-axis to do that job.

I've had fairly mixed results regarding the time it takes to dislodge that little filament booger _(not sure what else to call it)_, but the results are always the same - it will be knocked/pulled loose eventually.

You can play with different combinations to find the one that works best for you, my setup is as follows:
1) 02_LongNose
2) 01_RoundNose
3) 03_ShortNose
4) 01_RoundNose
5) 03_ShortNose
6) 01_RoundNose
7) 02_LongNose

The hooks will work perfectly fine with the stock Snapmaker enclosure _(I use one myself, so I designed it that way)_, but if you built your own similar to the Snapmaker where the rubber feet protrudes through the bottom of the enclosure, th