Thingiverse
SnapMaker Dremel Flex Shaft Mount
door CthulhuLabs
55
Downloads
24
Likes
1
Makes
This is designed to hold a Dremel Flex Shaft on a SnapMaker 3D printer.
Required hardware:
4x M4 15mm bolts
4x M4 8mm bolts
8x M4 nuts
1x Dremel Flex Shaft
Please note that I have not tested this at all. I am not sure I have it even in the correct place on the mount.
Required hardware:
4x M4 15mm bolts
4x M4 8mm bolts
8x M4 nuts
1x Dremel Flex Shaft
Please note that I have not tested this at all. I am not sure I have it even in the correct place on the mount.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!