Thingiverse
Snapmaker J1 Filament Guide
von DeSkwared
1
Downloads
2
Likes
0
Makes
Replacement for the factory 90-degree guide on the Snapmaker J1/J1s. This allows the use of typical bowden-style tubing. Use the same collet that comes with any of the pressure-fit bowden fittings (usually black or white plastic). This is designed to be tight, so is not really intended for removal of the tubing, once it is installed, and it does not require the spacer (though you can use one if your print seems to need it). Collet install can be a bit tricky, but it fits!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!