Thingiverse
SNAPMAKER SIMPLE ZERO (WITH EXTRAS)
von atooltoscream
125
Downloads
69
Likes
1
Makes
Someone was looking for a consistent way to hold their dice while laser engraving. This is my solution.
The zero point can be useful for things other than dice. The green stops in the picture were designed with die making in mind.
From some quick reading it sounds like the most common sizes for dice are 16mm and 19mm. The green stops should be able to accommodate both. See below for usage instructions
The zero point can be useful for things other than dice. The green stops in the picture were designed with die making in mind.
From some quick reading it sounds like the most common sizes for dice are 16mm and 19mm. The green stops should be able to accommodate both. See below for usage instructions
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
