snapmaker toolhead quick swap

Change your Toolheads for your Snapmaker in less then 10 seconds - with just one hand.
This Tool works with the Snapmaker Original and Snapmaker 2.0.

Attention:
- Due to the construction, the X-axis is shifted by 4mm (-4mm)
- Only three screws can be used for the 3D Module or an additional shorter screw is used
- for better gliding I used a little bit of WD40
- !!I adwise to open the sides of your toolheads before screwing the quick hitch to your toolheads, so you can be sure, that the screws can't damage something inside!!


Matching wall mount: https://www.thingiverse.com/thing:5569214

Print body all in one - Remix by SilverCat: https://www.thingiverse.com/thing:5850019

I'd be happy about your feedback!

https://www.instagram.com/reel/CjxjQ5Ij0B5/?utm_source=ig_web_copy_link

Follow me on Instagram @hard.holz

If you like my construction I would be happy about a small donation paypal.me/memmentaler