Snapmaker U1 Angled Hinge

Snapmaker U1 Screen Hinge ModThis little mod relocates and hinges the Snapmaker U1 screen to improve readability and usability. The hinge allows the display to tilt for a better viewing angle. The hinge design could probably be improved further. I originally tried to keep the profile as low as possible, and while the hinge isn’t perfect, it works well enough for my setup. For best results, print the screen holder face-down with supports. You can print it standing and the overhangs are ok, just the hinge gets a little wonky, personal preference really. I’ve uploaded a Bambu profile that I test printed successfully using PLA on a P1S, but the version I actually used was printed on the Snapmaker using PETG as the supports as it's so easy to remove.BOMM3 × 6 mm screws x2M3 × 16 mm screws x2M3 nuts x4Thin double-sided tape (tolerances are tight, so avoid thick foam tape)32-pin 0.5 mm pitch 100 mm FPC cable32-pin FPC extension boardLINK TO FPC CABLE - MAKE SURE TO SELECT 32 PINhttps://ww