Snapmaker U1 double auto feeder angle bracket

To allow both automatic feeders to operate from my SUNLU S4, I relocated them to the same side of the printer. I moved the RFID board from the left side to a position beneath the main board on the right. I fabricated a standoff for the RFID board and mounted it to the inside of the right panel using double-sided tape. It is easiest to secure the RFID board to the standoff with the original screws before attaching the assembly to the panel. For the left-side fan, I extended the wiring and routed it along the original path previously used by the FFC cable beneath the printer. To relocate the automatic feeders to one side of the printer, I remixed Simon_Zhi's model to allow for both automatic feeders to connect from the origional location. I also ran the wiring for both automatic feeders through the right side’s original hole. With the RFID board located in this position, the cable had plenty of length to reach the new feeder location above the original right feeder. I am still working on