Snapmaker U1 Filament feeder brackets.

UPDATE: I have added the feeder cover which replaces the original cover on the feeder both sides - the pipe inserts are the same, modified in Orca.
Credit to here for the original file: https://www.printables.com/model/1477419-snapmaker-u1-autofeeders-ptfe-tubing-attachment

A bracket which drops onto the feeder and utilises pipe fittings to move filaments to a dryer unit. At present fittings are 1/4" bsp so requires a tap to suit.All holes ready to tap with a 11.8mm hole at the 4 input heads.

Tap Set I purchased - https://amzn.eu/d/3KC9CSY
6mm Pipe - https://amzn.eu/d/fT3vzzZ - Lengths cut to 800mm, not tested longer
Pipe Fittings 1/4" x 6mm - https://amzn.eu/d/4FKkQTJ

Rough Video!! - https://www.youtube.com/shorts/Um7K8AHy1Fg

Due to the 1/4" fittings the filament may get stuck at the inlet to the feeder motor, you can either:
1) shake the ptfe tube a little to allow it to enter the feeder
2) remove the Ptfe tube and feed into feeder - be aware this will pull it into the feeder.