Slicer Discord
Snapper trick puzzle – 3D-Druckmodell von Thingiverse Thingiverse

Snapper trick puzzle

von giladger
51 Downloads
34 Likes
0 Makes
Zum Modell
Quoting [Wikipedia](https://en.wikipedia.org/wiki/Snapper_(puzzle)):
A snapper is a mechanical puzzle consisting of a pointed piece attached to a notched dowel and a hollow block with a secondary hole along its length through which a rubber-band is stretched (across the shaft) and tied off. A demonstrator inserts the dowel into the hollow block, hooks the rubber-band on the notch, pulls on the pointed end, and allows the dowel to snap back into place. The demonstrator hands the puzzle to an observer who cannot hook the rubber-band onto the dowel's notch. The demonstrator takes the puzzle back and makes it snap immediately. The trick is that the ends of the dowel are tapered so that the demonstrator can squeeze the fingers holding it together, causing it to snap into the block.


You can also watch this video (not mine): https://www.youtube.com/watch?v=Nhig3lCMP04
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen