Snapping Fidget Clicker

This is a simple fidget toy that snaps and clicks. When I was designing my Modular Stacking Rack for Soda Pop Can 12-Packs, I needed a connector for attaching two panels to each other. So I created the Cantilever Snap Fit Connector for that purpose. Then I discovered that I enjoyed snapping the plunger into the socket over and over. It is pretty satisfying. So I turned it into a fidget clicker. Enjoy! Insert the plunger into the body, with the stars aligned on the same end. You may need to pinch the sides of the plunger together a bit, by the nubs that stick out, in order to slide it into the body. But it should then slide pretty easily. It should click into place with about 1 cm sticking out of the body. If you snap the plunger in on one side, it will pop out on the other side by about 1 cm. The body prints standing up with a brim.