Snatch Block Pully

Designed a simple snatch block pully thing. No clue how much weight it can hold, likely depends on infill.

Made to be used with climbing rope, but I do not advise to use this for any climbing, use at your own risk.

Made to be printed support-less and printed with layer lines in mind for strength.

Tolerances are tight for rigidity and there are 2 options, one for plastic only print, and another for use with hardware.

2 standard skate bearings for the rope wheel in the hardware model, I haven't parted out a good nut and bolt for it yet.

Let me know what you think.