SNES Mini Pi

All thanks to blakefobrien for this fantastic model, but things were just not lining up for my Raspberry 3b+.

I added posts to keep the board level and raise it up from the floor as it was interfering with the leads on the bottom of the board. That meant I had to increase the height by a few millimeters. Also, the left seam was printing too fragile because of a recess on the inside, so I beefed that up. In addition to widening and centering the cutouts (I like bigger cutouts so cables fit completely into the sockets), I also enlarged the sd card opening underneath for easier card removal.

The fit is good enough to not need screws in the posts, but if you do use them to screw down the board, I suggest a dab of super glue around each of them so they don't pop off.

Print the base flat as is, with supports, and print the top standing on it's back for best results. The text printed fine at .12 layer height and 45 mm/s