Snorkel breather bracket

This is a little bracket that I designed to hold the tube in place for all of the engine, axle, and transmission breathers. The line runs up the snorkel, held in place with zipties, and then does a 180 through this bracket to ensure that water does not run into the line (and then into the oil of the aforementioned bits).

Known issues:

Due to the semi-rigid tubing, there is upwards torque on the part. Under high heat, the part will slowly bend and warp. Replacement is as simple as printing a new part and boring out the holes to suit your specific tubing diameter.

6/2023 - UPDATED with v2 and printed with ASA.