Thingiverse
Snorkelclip Simple
di d1rk058
7
Download
2
Likes
0
Makes
Simpel clip to connect a snorkel to your mask strap.
Works by threading zip-ties through the holes and around your snorkel. Inside curvature is for a 25mm diameter snorkel (Aqualung in my case), but most sizes will fit. Zip-tie holes are 8 x 1.5mm. Clip inside width and length are 4x30mm.
Be sure to print it laying on its side (see picture); this gives the highest strength for the 'hook' part
Works by threading zip-ties through the holes and around your snorkel. Inside curvature is for a 25mm diameter snorkel (Aqualung in my case), but most sizes will fit. Zip-tie holes are 8 x 1.5mm. Clip inside width and length are 4x30mm.
Be sure to print it laying on its side (see picture); this gives the highest strength for the 'hook' part
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
