Thingiverse
SnorkelPus
von mwillmek
4
Downloads
3
Likes
0
Makes
I love the Cute Mini Octopus by McGybeer!
I wanted to try my hand at adjusting the model. So...
A couple of different heads. The base and tentacle anchors are unchanged.
The Snorkel head requires supports under/in the mask. Slicing with Cura 5.3.1, I blocked supports in the tentacle anchors and underneath the hollow portion of the head. The Sunglasses version I was able to print without any supports, but mileage may vary.
The tentacles have a few added links and an enlarged 'foot' to allow for a 4mm diameter x 2mm deep cylindrical magnet. A version with no magnet hole is also provided.
The tentacles are modified to be snap-fit to the head. Cut away the tiny builtin support and press onto the head. They should fit on other remixes too.
I wanted to try my hand at adjusting the model. So...
A couple of different heads. The base and tentacle anchors are unchanged.
The Snorkel head requires supports under/in the mask. Slicing with Cura 5.3.1, I blocked supports in the tentacle anchors and underneath the hollow portion of the head. The Sunglasses version I was able to print without any supports, but mileage may vary.
The tentacles have a few added links and an enlarged 'foot' to allow for a 4mm diameter x 2mm deep cylindrical magnet. A version with no magnet hole is also provided.
The tentacles are modified to be snap-fit to the head. Cut away the tiny builtin support and press onto the head. They should fit on other remixes too.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
