Back
Snowball Maker – 3D printable model from MakerWorld MakerWorld
Outdoor Toys

Snowball Maker

1.8k Downloads
294 Likes
1.1k Makes
Download Model
The snowball clips sold are very large and require both hands to operate, which greatly reduces the efficiency: clamp the snow with both hands, release the clip, and hold the snowball with your hands, slowly, too slowly.Use this, insert your thumb into the round hole, clamp the small ball between your index and middle fingers, grab a handful of snow, and a snowball will be formed. Press it with the other hand to make it stronger, and then you can throw it out (pay attention to safety and do not
Category
Outdoor Toys
Source
MakerWorld
Published
16.12.2023
Updated
05.03.2026
Comments
0

Comments

No comments yet – be the first!
More Outdoor Toys Models All MakerWorld Models More by danielha2058

Similar Models

6 Suggestions

Add to Collection