Slicer Discord
Snowball Mini Trebuchet  – Modèle 3D imprimable de MakerWorld MakerWorld
Outdoor Toys

Snowball Mini Trebuchet

8 Téléchargements
12 Likes
0 Makes
Voir le modèle
This is a fun snowball launcher for snowball fights that will bring victory to you! ⭐ How to Use the Mini Trebuchet (Full Instructions)This mini trebuchet is designed to launch small snowballs, foam balls, cotton balls, marshmallows, or other soft, lightweight projectiles. It is easy to operate and safe when used properly. Follow the steps below for the best performance.📌 1. Set Up the TrebuchetPlace the trebuchet on a flat, hard surface like a table, floor, or driveway.Make sure the front (long arm side) is pointing toward your target.Keep the area clear in front of the trebuchet for at least 10–20 feet.📦 2. Add CounterweightYour trebuchet throws farther if the counterweight is heavier.Open the counterweight box (if yours is hollow).Add coins, bolts, washers, sand, or tiny rocks.Close it and make sure the weight is secure and will not spill out.Do not overfill; if the trebuchet flips forward when you fire, reduce weight.🎯 3. Load the ProjectileLift the long arm until the counterwei
Catégorie
Outdoor Toys
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Pourquoi ?
post-traitement important
Monobloc Visserie requise
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 2/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Post-traitement
Ponçage, Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection