Snowboard Wall Hanging Hooks

This is a snowboard mounting clip for use on a wall. There are plenty of other designs out there but many were more for display over function. i had this tight space behind my gym equipment in the garage that was a good space for it but many of the other designs i looked at were too small, not strong enough (especially if i left the boots in the bindings). IMPORTANT BEFORE PRINTING: if you are simply displaying a board without bindings, this clip should be strong enough at about a 50% infill (I recommend gyroid which will increase the print time but make the finished product much stronger. If you are hanging a large board with bindings (and definitely if you are hanging with boots) print at 100% infill or something close to it like 75% gyroid). I did break one printed at 50% with my largest board, bindings and boots. I reprinted at 100% and it's super strong! BEFORE YOU PRINT: consider increasing overall print strength by laying the hook on a ‘side’ before printing. It will dramati