Thingiverse
snowflake / keychain
von matheussdo
2
Downloads
2
Likes
0
Makes
I'm using orcaSlicer.
I created 2 colors of filament in the slicer, and for each piece I select a different filament to be printed, so the orcaSlicer pauses on each component.
Print with the flake side down to match the texture of your PEI board or glass.
Pay attention to the order in which the components are printed, I used:
Component4 - White color - Print priority: 1st
Component5 - Red color - Print priority: 2nd
I created 2 colors of filament in the slicer, and for each piece I select a different filament to be printed, so the orcaSlicer pauses on each component.
Print with the flake side down to match the texture of your PEI board or glass.
Pay attention to the order in which the components are printed, I used:
Component4 - White color - Print priority: 1st
Component5 - Red color - Print priority: 2nd
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
