Thingiverse
Snowflake
von cmcwithey
3
Downloads
2
Likes
0
Makes
The stl file is for 3d printing the snowflake.
The cnc file is for milling out the snowflake from a 6in x 6in x 1/8in plywood board with a 1/8in (3.175MM) 2flute endmill.
Origin is top of part at the center of the square.
It is Marlin based gcode for the snapmaker 2.0 and will run on the A350. It should also work on the A250, but I have not run it on one.
The cnc file is for milling out the snowflake from a 6in x 6in x 1/8in plywood board with a 1/8in (3.175MM) 2flute endmill.
Origin is top of part at the center of the square.
It is Marlin based gcode for the snapmaker 2.0 and will run on the A350. It should also work on the A250, but I have not run it on one.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!