Thingiverse
SnusMaster
por uvens
27
Descargas
30
Likes
1
Makes
2020-05-21
A comment from https://www.thingiverse.com/Goofster who made this is to scale down all parts to 80% to get the correct size.
2018-12-13
Made a stronger model of the outer shell. Noticed that if using old PLA it could break so I made a stronger model called snusmaster_v2.stl
A charger that can be used for snuff tobacco. Apply a slice of snuff straight from the dose to the mouth without smearing your fingers.
Note: Tobacco can be dangerous to your health!
Can be printed in PLA in one piece. Infill 100%, resolution 0.23, 3 shell to make it sealed. Spent very little support. Lowered the print speed a little. You can tap a little on the inner bottom to loosen the inner part. Maybe ABS is best but trickier to print.
A comment from https://www.thingiverse.com/Goofster who made this is to scale down all parts to 80% to get the correct size.
2018-12-13
Made a stronger model of the outer shell. Noticed that if using old PLA it could break so I made a stronger model called snusmaster_v2.stl
A charger that can be used for snuff tobacco. Apply a slice of snuff straight from the dose to the mouth without smearing your fingers.
Note: Tobacco can be dangerous to your health!
Can be printed in PLA in one piece. Infill 100%, resolution 0.23, 3 shell to make it sealed. Spent very little support. Lowered the print speed a little. You can tap a little on the inner bottom to loosen the inner part. Maybe ABS is best but trickier to print.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
