Slicer Discord
Snuzpod shelf bracket – 3D-Druckmodell von Thingiverse Thingiverse

Snuzpod shelf bracket

von stuey_p22
8 Downloads
8 Likes
0 Makes
Zum Modell
You need both left hand and right hand brackets. If like us you have a Snuzpod next to the bed and had to move your bedside cabinet. For the shelf just use a piece of 18mm thick Melamine coated chipboard cut to the desired length. Don't make it too deep though. I've not tested the weight capacity, but I figure it should be good enough for a lamp or glass of water, oh and the all important phone.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
großer Druck
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 2/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
200 mm (Groß)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen