SO08 IC adapter

I usually test my electronic circuits on a board model before building. This is difficult with SMD components, so I made an adapter. It was originally made for the ATTINY85 IC, but it can be used with any SO08 type IC.
When inserting the IC, you have to pay attention to the placement of pin 1, as shown in the photo.
I bought the printed circuit board on the Internet. The soldered pin rows have to be inserted into the adapter. This requires a little filing.
M3 threads need to be cut into the holes of the "Adapter_test".
According to the datasheet, the IC legs are 0.2 mm lower than the body. If this does not provide proper contact, the legs can be carefully bent down.
Material PLA
Nozzle 0.4 mm
Printing temperature 215 degrees
Table temperature 60 degrees