Back
Soap dish – 3D printable model from MakerWorld MakerWorld
Other House Models

Soap dish

4 Downloads
1 Likes
3 Makes
Download Model
This soap dish fits a standard bar of soap and has holes in the bottom and front to allow any soapy water to flow out. I have been using this in my prep sink for the last three years and it's great. It does have a lifted bottom because my sink has a strange bump that I wanted to cover with this. You can always lower it down on the plate to trim off the bottom so it is flat if that is what you are looking for. I hope this helps someone.
Category
Other House Models
Source
MakerWorld
Published
04.07.2024
Updated
26.08.2025
Comments
0

Comments

No comments yet – be the first!
More Other House Models Models All MakerWorld Models More by Mike Jimmy

Similar Models

6 Suggestions

Add to Collection