Soap Dish

This is a soap dish that a family member asked me to make for their bathroom sink.

-- These are printed with supports. Raft is optional.

v1.0 Base - This base has a flat bottom and prints without supports.

v1.0 Tray - This tray is before I cut the angle off the corner. I will be creating a base without a spout for the water to escape. This will be the tray for the new base.

v1.1 Base - This base has a slightly curved spout. This should be printed level with supports.

v1.1 Tray - This base has the angle to match the base. This should be printed with supports.