Thingiverse
Soap Dish, Wall Mounted
by Pendzid
9
Downloads
15
Likes
0
Makes
I designed this simple soap dish for use in my shower, but this could be great for bathroom sinks, tubs, kitchens, or even laundry/utility rooms.
You can use two large Command adhesive strips to mount this anywhere you need a self-draining, bar soap sized shelf!
When I design things like this, I try to keep simplicity and ease of printing in mind avoiding adhesion and supports as much as possible.
Unfortunately I DO recommend printing this with basic supports ON. There is a lip around the top of the dish that makes a heck of a bridge. Use supports, it's not that much material and they'll come off easy and clean.
Estimated print time for a sonic pad using the fast PLA setting is 2 hours, 43 minutes.
If you do decide to print one of these soap dishes and it works out great for you, **consider leaving a tip, it's much appreciated**
You can use two large Command adhesive strips to mount this anywhere you need a self-draining, bar soap sized shelf!
When I design things like this, I try to keep simplicity and ease of printing in mind avoiding adhesion and supports as much as possible.
Unfortunately I DO recommend printing this with basic supports ON. There is a lip around the top of the dish that makes a heck of a bridge. Use supports, it's not that much material and they'll come off easy and clean.
Estimated print time for a sonic pad using the fast PLA setting is 2 hours, 43 minutes.
If you do decide to print one of these soap dishes and it works out great for you, **consider leaving a tip, it's much appreciated**
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!