Soap Dispenser Tray

In our house we use these Method refillable foam-soap dispensers, which are great except that my kids have a hard time pushing them straight down. On a tiny sink ledge like in the picture, this means the soap dispenser is constantly ending up on the floor.

So, I designed this little holder for the dispenser. It mounts on the wall with two drywall anchors, and also rests on the sink ledge, so there is lots of strength underneath it. There is also has a little hole for stray water to drain into the sink.

It fits this kind of bottle, which has a diameter at the base of just over 80mm: http://www.amazon.com/Method-Foaming-Hand-Wash-Waterfall/dp/B004O61852

The filament ridges will collect a bit of grime, but it easily wipes clean. You might want to put a bit of caulking around the rim where it rests on the wall, if your kids are as messy as mine.

See the print instructions for details. Designed in Autodesk Fusion 360.