soap holder base

This soap base is designed in moderate size. The outer contour is around 1375 cm, which should be able to hold most ordinary soaps. I designed an outlet and a slope at the bottom so that the soap water could be automatically drained out.
Attention: According to the test of my prototype, if there are too many bubbles inside, the flow efficiency would be weakened.
By the way, if you need the filter, you could take a view of my other designs. Alternatively, this soap base could also suit other designers' creatures. The inner support groove is designed in a rectangle.

Printing:

Ring - Infil to add weight, supports needed for spade inset. Letter embossing doesn't need it.
Spade - Infil to add weight, no supports
Letters - Print flat, already scaled to fit nicely in the embossing
Star - Infil to add weight.

Full print with 4x4x4 walls/top/bottom and 38% infil came to about 48g in weight.

Glue in lettering and spade. Star may need minor sanding but should push fit into th