Thingiverse
Soap Holder
von dforsythe
0
Downloads
1
Likes
0
Makes
Area to hold soap is 2.5" by 3". Water drains out the front into the sink.
Supports should be used only touching build plate. I used 0.2mm layer height, but smaller is fine as well.
Supports should be used only touching build plate. I used 0.2mm layer height, but smaller is fine as well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
![Sistema "Round Dish" Ersatzdichtungen [DE] | Sistema "Round Dish" replacement seals[EN]](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Frenders%2F91%2F31%2F62%2F2e%2Fbb%2Fceb3c38fdea9ed6fa665d6357843894f_display_large.jpg&w=400&h=300)
